When.com Web Search

  1. Ads

    related to: 3.5 floppy disk drive internal

Search results

  1. Results From The WOW.Com Content Network
  2. Floppy disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk_drive_interface

    3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...

  3. Floppy disk - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk

    8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...

  4. SuperDrive - Wikipedia

    en.wikipedia.org/wiki/SuperDrive

    Internal SuperDrive floppy drive on a Macintosh LC II. The term was first used by Apple Computer in 1988 to refer to their 1.44 MB 3.5 inch floppy drive.This replaced the older 800 KB floppy drive that had been standard in the Macintosh up to then, but remained compatible [citation needed] in that it could continue to read and write both 800 KB (double-sided) and 400 KB (single-sided) floppy ...

  5. File:Floppy disk internal diagram.svg - Wikipedia

    en.wikipedia.org/wiki/File:Floppy_disk_internal...

    English: Diagram illustrating the basic internal parts of a 3.5" floppy disk. Document labels rendered as numbers to aid in internationalization. Note: The unlabeled square in the upper left is the approximate location of the write protection tab.

  6. List of disk drive form factors - Wikipedia

    en.wikipedia.org/wiki/List_of_disk_drive_form...

    [citation needed] With increasing sales of microcomputers having built in floppy-disk drives (FDDs), HDDs that would fit to the FDD mountings became desirable. Thus HDD Form factors, initially followed those of 8-inch, 5.25-inch, and 3.5-inch floppy disk drives. Because there were no smaller floppy disk drives, smaller HDD form factors ...

  7. Drive bay - Wikipedia

    en.wikipedia.org/wiki/Drive_bay

    They were 3 + 1 ⁄ 4 inches (82.6 mm) high, 5 + 3 ⁄ 4 inches (146.1 mm) wide, and up to 8 inches (203.2 mm) deep, used mainly for hard disk drives and floppy disk drives. This is the size of the internal (screwed) part of the bay, as the front side is actually 5 + 7 ⁄ 8 inches (149.2 mm). The difference between those widths and the name of ...