Ads
related to: edelbrock 1406 stock jet size chart printable
Search results
Results From The WOW.Com Content Network
There were several versions made, for both stock replacement and "performance" applications. [citation needed] One version was specifically intended as a replacement for Carter ThermoQuad carburetors. [citation needed] The Edelbrock Q-jets have been discontinued, although at this time Edelbrock still supplies some replacement parts. [citation ...
Edelbrock, LLC is an American manufacturer of specialty automotive and motorcycle parts. The company is headquartered in the Memphis area (specifically Olive Branch, Mississippi), with a Southern California R&D Tech Center located in Cerritos, CA. The Edelbrock Sand Cast and Permanent Mold Manufacturing foundries are located in San Jacinto, CA.
Weber pioneered the use of two-stage twin-barrel carburetors, with two venturis of different sizes (the smaller one for low-speed/rpm running and the larger one optimised for high-speed/rpm use). In the 1930s, Weber began producing twin-barrel carburetors for motor racing, where two barrels of the same size were used. These were arranged so ...
The pilot circuit was moved to the inlet side if the slide. The air bleed was taken from the incoming air rather than the outside, reducing the possibility of dirt ingress to the circuit. The moving of the pilot jet allowed far greater downdraught angles without the jet flooding. [32] [39] The GP2 was available in the same sizes as the original GP.
The propelling nozzle converts a gas turbine or gas generator into a jet engine. Power available in the gas turbine exhaust is converted into a high speed propelling jet by the nozzle. The power is defined by typical gauge pressure and temperature values for a turbojet of 20 psi (140 kPa) and 1,000 °F (538 °C). [18]
The 428 Cobra Jet was a performance version of the 428 FE. Launched in April 1968, it was built on a regular production line using a variety of cylinder heads [30] combined with a 735 CFM Holley four-barrel carburetor. The Cobra Jet used heavier connecting rods with a 13/32 rod bolt and a nodular iron crankshaft casting #1UB.
The prototype made its first flight on 3 September 1981. In August 1973, Hawker Siddeley launched a new 70-seat regional airliner project, the HS.146, to fill the gap between turboprop-powered airliners such as the Hawker Siddeley HS.748 and the Fokker F27 Friendship and small jet airliners such as the BAC One-Eleven and Boeing 737.
The McDonnell Douglas F-15 Eagle was introduced by the USAF to replace its fleet of McDonnell Douglas F-4 Phantom IIs.Unlike the F-4, the F-15 was designed for air superiority with little consideration for a ground-attack role; the F-15 Special Project Office opposed the idea of F-15s performing interdiction, giving rise to the phrase "Not a pound for air to ground."