Ads
related to: industrial gas turbine diagram worksheet
Search results
Results From The WOW.Com Content Network
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
Closed-cycle gas turbine schematic C compressor and T turbine assembly w high-temperature heat exchanger ʍ low-temperature heat exchanger ~ mechanical load, e.g. electric generator. A closed-cycle gas turbine is a turbine that uses a gas (e.g. air, nitrogen, helium, argon, [1] [2] etc.) for the working fluid as part of a closed thermodynamic ...
A free-piston gas generator is a free-piston engine whose exhaust is used to power a gas turbine. It combines the functions of compressor and combustion chamber in one unit. These machines were quite widely used in the period 1930–1960 but then fell out of favour. [1]
It is a no-load condition in a gas turbine, turbocharger or industrial axial compressor but overload in an industrial centrifugal compressor. [29] Hiereth et al. [30] shows a turbocharger compressor full-load, or maximum fuelling, curve runs up close to the surge line. A gas turbine compressor full-load line also runs close to the surge line.
Unlike a compressor or fan, surge or stall does not occur in a turbine. This is because the gas flows through the turbine in its natural direction, from high to low pressure. As a result, there is no surge line marked on a turbine map. Working lines are difficult to see on a conventional turbine map because the speed lines bunch up.
A simple-cycle combustion turbine (SCCT) is a type of gas turbine typically used in the power generation, aviation , and oil and gas industries (for electricity generation and mechanical drives). The simple-cycle combustion turbine follows the Brayton Cycle and differs from a combined cycle operation in that it has only one power cycle (i.e. no ...
The General Electric LM2500 is an industrial and marine gas turbine produced by GE Aviation.The LM2500 is a derivative of the General Electric CF6 aircraft engine.. As of 2004, the U.S. Navy and at least 29 other navies had used a total of more than one thousand LM2500/LM2500+ gas turbines to power warships. [1]
The LMS100 comprises a low-pressure compressor, an intercooler, a supercore and a power turbine. The supercore (comprising a HP compressor, compressor rear frame, high-pressure turbine and intermediate pressure turbine) is a further development of the LM6000, which in turn was based on the CF6-80C2. The low-pressure compressor is from the 6FA ...