Search results
Results From The WOW.Com Content Network
A PPTP tunnel is instantiated by communication to the peer on TCP port 1723. This TCP connection is then used to initiate and manage a GRE tunnel to the same peer. The PPTP GRE packet format is non standard, including a new acknowledgement number field replacing the typical routing field in the GRE header. However, as in a normal GRE connection ...
In computer networks, a tunneling protocol is a communication protocol which allows for the movement of data from one network to another. They can, for example, allow private network communications to be sent across a public network (such as the Internet), or for one network protocol to be carried over an incompatible network, through a process called encapsulation.
SSTP was introduced in 2007 [3] and available on Windows Vista SP1 and later, in RouterOS since version 5.0, and in SEIL since its firmware version 3.50. It is fully integrated with the RRAS architecture in these operating systems, allowing its use with Winlogon or smart-card authentication, remote-access policies and the Windows VPN client. [4]
Virtual private network (VPN) is a network architecture for virtually extending a private network (i.e. any computer network which is not the public Internet) across one or multiple other networks which are either untrusted (as they are not controlled by the entity aiming to implement the VPN) or need to be isolated (thus making the lower network invisible or not directly usable).
An ephemeral port is a communications endpoint of a transport layer protocol of the Internet protocol suite that is used for only a short period of time for the duration of a communication session. Such short-lived ports are allocated automatically within a predefined range of port numbers by the IP stack software of a computer operating system.
The process of setting up an L2TP/IPsec VPN is as follows: Negotiation of IPsec security association (SA), typically through Internet key exchange (IKE). This is carried out over UDP port 500, and commonly uses either a shared password (so-called "pre-shared keys"), public keys, or X.509 certificates on both ends, although other keying methods ...
MPLS VPN is a family of methods for using Multiprotocol Label Switching (MPLS) to create virtual private networks (VPNs). MPLS VPN is a flexible method to transport and route several types of network traffic using an MPLS backbone. There are three types of MPLS VPNs deployed in networks today: 1. Point-to-point 2. Layer 2 (VPLS) 3.
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.