Search results
Results From The WOW.Com Content Network
The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.
The access router gives the dial-up nodes IP addresses in the range 192.168.0.128 – 192.168.0.254; for this example, assume a dial-up node gets IP address 192.168.0.254. The access router uses proxy ARP to make the dial-up node present in the subnet without being wired into the Ethernet: the access router 'publishes' its own MAC address for ...
A LAG is a method of inverse multiplexing over multiple Ethernet links, thereby increasing bandwidth and providing redundancy. It is defined by the IEEE 802.1AX-2008 standard, which states, "Link Aggregation allows one or more links to be aggregated together to form a Link Aggregation Group, such that a MAC client can treat the Link Aggregation Group as if it were a single link."
The user's computer has an IP address stuffed manually into its address table (normally with the arp command with the MAC address taken from a label on the device) The computer sends special packets to the device, typically a ping packet with a non-default size.
This address is used by only one physical router at a time, and it will reply with this MAC address when an ARP request is sent for the virtual router's IP address. Physical routers within the virtual router must communicate within themselves using packets with multicast IP address 224.0.0.18 and IP protocol number 112 [1] for IPv4, or ff02::12 ...
Its original target was small appliances like routers, VPN gateways, or embedded x86 devices. However, it supports hosting other Linux guest OSes under LXC control, making it an attractive hosting solution as well. Uses Busybox and musl. ClearOS: Active: Red Hat Enterprise Linux derivative: x86, x86-64: GPL and others: Free or paid registration
IEEE 1905.1 is an IEEE standard which defines a network enabler for home networking supporting both wireless and wireline technologies: IEEE 802.11 (marketed under the Wi-Fi trademark), IEEE 1901 (HomePlug, HD-PLC) power-line networking, IEEE 802.3 Ethernet and Multimedia over Coax (MoCA).
Anycast is a network addressing and routing methodology in which a single IP address is shared by devices (generally servers) in multiple locations. Routers direct packets addressed to this destination to the location nearest the sender, using their normal decision-making algorithms, typically the lowest number of BGP network hops.