Search results
Results From The WOW.Com Content Network
The coefficient of variation may not have any meaning for data on an interval scale. [2] For example, most temperature scales (e.g., Celsius, Fahrenheit etc.) are interval scales with arbitrary zeros, so the computed coefficient of variation would be different depending on the scale used.
A number have been summarized and devised by Wilcox (Wilcox 1967), (Wilcox 1973), who requires the following standardization properties to be satisfied: Variation varies between 0 and 1. Variation is 0 if and only if all cases belong to a single category. Variation is 1 if and only if cases are evenly divided across all categories. [1]
In statistics, McKay's approximation of the coefficient of variation is a statistic based on a sample from a normally distributed population. It was introduced in 1932 by A. T. McKay. [1] Statistical methods for the coefficient of variation often utilizes McKay's approximation. [2] [3] [4] [5]
In fluid dynamics, normalized root mean square deviation (NRMSD), coefficient of variation (CV), and percent RMS are used to quantify the uniformity of flow behavior such as velocity profile, temperature distribution, or gas species concentration. The value is compared to industry standards to optimize the design of flow and thermal equipment ...
Coefficient of variation versus deviation in reference ranges established by assuming normal distribution when there is actually a log-normal distribution. This difference can be put solely in relation to the coefficient of variation, as in the diagram at right, where: Coefficient of variation = s.d. / m where: s.d. is the standard ...
In probability theory and statistics, the index of dispersion, [1] dispersion index, coefficient of dispersion, relative variance, or variance-to-mean ratio (VMR), like the coefficient of variation, is a normalized measure of the dispersion of a probability distribution: it is a measure used to quantify whether a set of observed occurrences are clustered or dispersed compared to a standard ...
In descriptive statistics, the range of a set of data is size of the narrowest interval which contains all the data. It is calculated as the difference between the largest and smallest values (also known as the sample maximum and minimum). [1] It is expressed in the same units as the data. The range provides an indication of statistical ...
The table shown on the right can be used in a two-sample t-test to estimate the sample sizes of an experimental group and a control group that are of equal size, that is, the total number of individuals in the trial is twice that of the number given, and the desired significance level is 0.05. [4] The parameters used are: