Search results
Results From The WOW.Com Content Network
Genuine MAPP gas can be used in combination with oxygen for heating, soldering, brazing and even welding because of its high flame temperature of 2925 °C (5300 °F) in oxygen. Although acetylene has a higher flame temperature (3160 °C, 5720 °F), MAPP has the advantage that it requires neither dilution nor special container fillers during ...
Converting units of temperature differences (also referred to as temperature deltas) is not the same as converting absolute temperature values, and different formulae must be used. To convert a delta temperature from degrees Fahrenheit to degrees Celsius, the formula is {ΔT} °F = 9 / 5 {ΔT} °C.
It is measured as a unit of energy per unit mass or volume of substance. The HHV is determined by bringing all the products of combustion back to the original pre-combustion temperature, including condensing any vapor produced. Such measurements often use a standard temperature of 25 °C (77 °F; 298 K) [citation needed].
Burn rate (typically expressed in mm/s or in/s) is the sample length over time at a given pressure and temperature. For solid fuel propellant, the most common method of measuring burn rate is the Crawford Type Strand Burning Rate Bomb System [ 3 ] (also known as the Crawford Burner or Strand Burner), as described in MIL-STD-286C.
MAPP gas can be used at much higher pressures than acetylene, sometimes up to 40 or 50 psi in high-volume oxy-fuel cutting torches which can cut up to 12-inch-thick (300 mm) steel. Other welding gases that develop comparable temperatures need special procedures for safe shipping and handling.
The degree Celsius (°C) can refer to a specific temperature on the Celsius scale as well as a unit to indicate a temperature interval (a difference between two temperatures). From 1744 until 1954, 0 °C was defined as the freezing point of water and 100 °C was defined as the boiling point of water, both at a pressure of one standard atmosphere.
Isotherms of an ideal gas for different temperatures. The curved lines are rectangular hyperbolae of the form y = a/x. They represent the relationship between pressure (on the vertical axis) and volume (on the horizontal axis) for an ideal gas at different temperatures: lines that are farther away from the origin (that is, lines that are nearer to the top right-hand corner of the diagram ...
At standard temperature and pressure, oxyhydrogen can burn when it is between about 4% and 95% hydrogen by volume. [5] [4] When ignited, the gas mixture converts to water vapor and releases energy, which sustains the reaction: 241.8 kJ of energy for every mole of H 2 burned.