Ads
related to: ahci driver for windows 10bit-guardian.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
Note: The RST drivers can be used for RAID and also on a single drive as it contains an AHCI driver. There is a bug in the version 12.5.0.1066 RST driver, which cause TRIM commands not to pass through the RAID driver to the drives. TRIM is disabled using this driver.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
The appropriate driver must be loaded into the operating system to enable NCQ on the host bus adapter. [3] Many newer chipsets support the Advanced Host Controller Interface (AHCI), which allows operating systems to universally control them and enable NCQ. DragonFly BSD has supported AHCI with NCQ since 2.3 in 2009.
It is confirmed that with native Microsoft drivers the TRIM command works on Windows 7 in AHCI and legacy IDE / ATA Mode. [44] Windows 8 and later Windows operating systems support the unmap command for devices that use the SCSI driver stack, including USB Attached SCSI Protocol (UASP).
Intel i945GC northbridge with Pentium Dual-Core microprocessor. This article provides a list of motherboard chipsets made by Intel, divided into three main categories: those that use the PCI bus for interconnection (the 4xx series), those that connect using specialized "hub links" (the 8xx series), and those that connect using PCI Express (the 9xx series).
SRT is managed by Intel Rapid Storage Technology software version 10.5 or later, [2] and implemented both in its device driver and in the Z68 motherboard's firmware . It is available only when the (integrated) disk controller is configured in RAID mode (but not AHCI or IDE modes) by implementing a style of RAID 0 striping.
In 2008, Hard Disk Sentinel DOS version was released in different formats on bootable pen drive, CD, floppy. Usable when no operating system installed (or if the system is not bootable otherwise) to detect and display temperature, health status of IDE, SATA hard disk drives and with limited AHCI controller support.