Search results
Results From The WOW.Com Content Network
A circuit symbol for a positive-edge-triggered JK flip-flop JK flip-flop timing diagram. The JK flip-flop, augments the behavior of the SR flip-flop (J: Set, K: Reset) by interpreting the J = K = 1 condition as a "flip" or toggle command.
The Timing closure in VLSI design and electronics engineering is the process by which a logic design of a clocked synchronous circuit consisting of primitive elements such as combinatorial logic gates (AND, OR, NOT, NAND, NOR, etc.) and sequential logic gates (flip flops, latches, memories) is modified to meet its timing requirements.
In digital computing, the Muller C-element (C-gate, hysteresis flip-flop, coincident flip-flop, or two-hand safety circuit) is a small binary logic circuit widely used in design of asynchronous circuits and systems. It outputs 0 when all inputs are 0, it outputs 1 when all inputs are 1, and it retains its output state otherwise.
At each advance, the bit on the far left (i.e. "data in") is shifted into the first flip-flop's output. The bit on the far right (i.e. "data out") is shifted out and lost. The data is stored after each flip-flop on the "Q" output, so there are four storage "slots" available in this arrangement, hence it is a 4-bit register.
A timing diagram can contain many rows, usually one of them being the clock. It is a tool commonly used in digital electronics, hardware debugging, and digital communications. Besides providing an overall description of the timing relationships, the digital timing diagram can help find and diagnose digital logic hazards .
The output of a flip-flop is constant until a pulse is applied to its "clock" input, upon which the input of the flip-flop is latched into its output. In a synchronous logic circuit, an electronic oscillator called the clock generates a string (sequence) of pulses, the "clock signal".
Here, the contamination delay is the amount of time needed for a change in the flip-flop clock input to result in the initial change at the flip-flop output (Q). If there is insufficient delay from the output of the first flip-flop to the input of the second, the input may change before the hold time has passed. Because the second flip-flop is ...
The timing diagram is for a positive edge triggered JK flip-flop, and the article states "The flip-flop is positive-edge triggered (rising clock pulse) as seen in the timing diagram." This is true, but the circuit symbol diagram shows a negative edge triggered flip-flop(clock connection arrow pointing inwards) which could cause some confusion ...