Search results
Results From The WOW.Com Content Network
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system , a port is a logical construct that identifies a specific process or a type of network service .
The services and protocols specified in IEEE 802 map to the lower two layers (data link and physical) of the seven-layer Open Systems Interconnection (OSI) networking reference model. IEEE 802 divides the OSI data link layer into two sub-layers: logical link control (LLC) and medium access control (MAC), as follows:
In addition, a 4-byte CRC is appended to the end of each frame. This CRC is in addition to any frame checking that the Ethernet frame requires. The fields in an ISL header identify the frame as belonging to a particular VLAN. A VLAN ID is added only if the frame is forwarded out a port configured as a trunk link.
Network-attached storage Hardware / Storage Computer data storage: NAT: Network Address Translation Internet Layer Cisco Internet Protocol Journal: A look Inside Network Address Translators: NBMA: Non-Broadcast Multiple Access (e.g. Frame Relay ATM) Telecom See ATM, Frame Relay and X.25, for examples. NIC: Network Interface Card Physical layer ...
A computer port is a hardware piece on a computer where an electrical connector can be plugged to link the device to external devices, such as another computer, a peripheral device or network equipment. [1] This is a non-standard term.
Media Redundancy Protocol (MRP) is a data network protocol standardized by the International Electrotechnical Commission as IEC 62439-2. It allows rings of Ethernet switches to overcome any single failure with recovery time much faster than achievable with Spanning Tree Protocol . [ 1 ]
EtherNet/IP (IP = Industrial Protocol) [1] is an industrial network protocol that adapts the Common Industrial Protocol (CIP) to standard Ethernet. [2] EtherNet/IP is one of the leading industrial protocols in the United States and is widely used in a range of industries including factory, hybrid and process.
The physical coding sublayer (PCS) is a networking protocol sublayer in the Fast Ethernet, Gigabit Ethernet, and 10 Gigabit Ethernet standards. It resides at the top of the physical layer (PHY), and provides an interface between the physical medium attachment (PMA) sublayer and the media-independent interface (MII).