Ad
related to: tandem axle slipper spring setup manual instructions free printableusermanualsonline.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Slipper clutches have also been used to a lesser extent on automobiles, primarily those powered by motorcycle engines. They can also be found on racing remote control cars . [ citation needed ] Some experimental aircraft use a slipper clutch to control torsional resonance in the drive train and protect the engine from shock in the event of a ...
The GMC Astro and Chevrolet Titan are Class 8 cabover-engine (COE) trucks, sold in both single and tandem rear axle configurations. In contrast to the Crackerbox, the cab of the Astro was lengthened nearly six inches into a 54-inch BBC length with two sleeper cab configurations available.
These models of trucks were produced in 27,500 lb (12,500 kg) to 60,920 lb (27,630 kg) Gross Vehicle Weight Ratings (the loaded weight of the truck), with both single and tandem rear axle models. The Fleetstar line was larger than the Loadstar (International's medium duty lineup during this time) and smaller than the Paystar (severe service ...
5-link live axle suspension. In automotive suspensions, a suspension link, control link or link is a suspension member, that attaches at only two points. One point being the body or frame of the vehicle and the other point attaching to the knuckle, upright, axle or another link. The link pivots on either a bushing or a ball joint at each ...
The Dana Holding Corporation manufactured the TTB axle for Ford. It uses a universal joint in the center that allows the wheels to move independently of each other. The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length.
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
The semi-floating axle setup is commonly used on half-ton and lighter 4×4 trucks in the rear. This setup allows the axle shaft to be the means of propulsion, and also support the weight of the vehicle. The main difference between the full- and semi-floating axle setups is the number of bearings.