Search results
Results From The WOW.Com Content Network
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, ... ≡ 1 ft/h = 8.4 6 × 10 −5 m/s
For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
Toggle Representable numbers, conversion and rounding subsection. 6.1 Rounding modes. ... 1 5 2 8 Half-precision: 1 5 10 16 Bfloat16: 1 8 7 16 TensorFloat-32 1 8 10 19
Therefore with a 12-gauge, it would take 12 balls of lead of the same size as the 12 gauge shotgun's inner bore diameter to weigh 1 pound (453.6 g). [5] The term is related to the measurement of cannons , which were also measured by the weight of their iron round shot ; an eight-pounder would fire an 8-pound (3.6 kg) ball.
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]
1.0 imp gal (4.5 L; 1.2 US gal) impgal l; impgal L; impgal USgal; impgal U.S.gal; impgal USdrygal; impgal U.S.drygal; imperial quart: impqt imp qt 1/4 imp gal or 40 imp fl oz 1.0 imp qt (1,100 ml; 38 US fl oz) imperial pint: imppt imp pt 1/8 imp gal or 20 imp fl oz 1.0 imp pt (0.57 L) imperial fluid ounce: impoz (impfloz) imp fl oz
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.