Ads
related to: ultralight friction drives for motors motorcycle repair kit
Search results
Results From The WOW.Com Content Network
The 165 cc, air-cooled, flat twin two-stroke engine drove the right-hand rear wheel by chain, and a variable-speed friction drive transmission was used, giving two forwards speeds and reverse. A top speed of 30 mph was claimed. [2] A motorcycle using the same engine, also with friction drive, was also offered for £28 10 shillings.
In 2015, Royal Enfield, a subsidiary of Eicher Motors, India-based motor vehicle manufacturers, acquired Harris Performance for an undisclosed sum. The company had a long relationship with Royal Enfield and was responsible for the chassis development of the brand's models Continental GT cafe racer and the Himalayan ADV bike.
The C42 is manufactured with either an 80 hp (60 kW) Rotax 912 engine or a 100 hp (75 kW) Rotax 912s engine. The Rotax engine has a low fuel consumption and relatively low noise. The engine drives the propeller, which has ground-adjustable pitch, through a gearbox with a 2.273:1 reduction ratio. Ikarus C42
Ixion engine on a Komet motorised bicycle, ca. 1902. This system is used, for example, to drive the spools in some tape recorders.In a typical configuration, one of the cylinders is the axle of an electric motor, say 1 mm in diameter, while the other is a disk with a hard rubber rim, say 50 mm in diameter, yielding a 1:50 mechanical advantage.
ATK is an American motorcycle and all-terrain vehicle company founded in 1985 and located in Centerville, Utah, USA. [1] As of 2016, it has been operating primarily to support previously sold models through parts and service manual distribution.
A belt reduction drive system, fuel injection, tuned exhaust and electric start are optional. [1] [2] The engine runs on a 50:1 pre-mix of unleaded 93 octane auto fuel and oil. Recommended time between overhauls is 1000 hours. [1] [2] The F-23 produces 50 hp (37 kW) at 6150 rpm and 40 hp (30 kW) at 5500 rpm. [1] [2]