Search results
Results From The WOW.Com Content Network
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
A group of tell-tales showing lights for "brake fluid", "stop lamp" and "check engine" Graphical tell-talesA tell-tale, sometimes called an idiot light [1] or warning light, is an indicator of malfunction or operation of a system, indicated by a binary (on/off) illuminated light, symbol or text legend.
When it was initially published in 1968, [10] Motor Vehicle Safety Standard No. 108 was part of 49 CFR 371.21, incorporating several SAE recommended practices by reference. [11] The 1969 version of FMVSS 108 allowed the use of two headlamps, each 7 in (180 mm) in diameter, or four smaller 5 + 3 ⁄ 4 in (150 mm) headlamps. [11]: Table I
A leak changes the hydraulics of the pipeline, and therefore changes the pressure or flow readings after some time. Local monitoring of pressure or flow at only one point can therefore provide simple leak detection. As it is done locally it requires in principle no telemetry. It is only useful in steady-state conditions, however, and its ...
OBDII + catalytic converter tamper check + fuel cap leak test for 1996 or later vehicles. Tailpipe/tampering testing for 1995 and older vehicles. Any diesel vehicle with a model year of 1975 and newer and a GVWR of 10,500 lbs or less. Annual testing. OBDII + catalytic converter tamper check + fuel cap leak test for 2002 or later vehicles.
The inspector will use visible light with adequate intensity (100 foot-candles or 1100 lux is typical) for visible dye penetrant. Ultraviolet (UV-A) radiation of adequate intensity (1,000 micro-watts per centimetre squared is common), along with low ambient light levels (less than 2 foot-candles) for fluorescent penetrant examinations.
The dandy roll is a light roller covered by material similar to window screen that is embossed with a pattern. Faint lines are made by laid wires that run parallel to the axis of the dandy roll, and the bold lines are made by chain wires that run around the circumference to secure the laid wires to the roll from the outside.
In 1956, the United States, Canada, and Mexico came to an agreement with the American Association of Motor Vehicle Administrators, the Automobile Manufacturers Association and the National Safety Council that standardized the size for license plates for vehicles (except those for motorcycles) at 6 inches (15 cm) in height by 12 inches (30 cm) in width, with standardized mounting holes. [3]