Search results
Results From The WOW.Com Content Network
The various types of such rotor wings may be classified according to the axis of the rotor. Types include: [1] [2] Vertical-axis. Conventional rotary wings as used by modern rotorcraft. Spanwise horizontal-axis. Wing rotor: an airfoil-section horizontal-axis rotor which creates the primary lift. Magnus rotor: a rotor which creates lift via the ...
Some rotary wing aircraft are designed to stop the rotor for forward flight so that it then acts as a fixed wing. For vertical flight and hovering it spins to act as a rotary wing or rotor, and for forward flight at speed it stops to act as a fixed wing providing some or all of the lift required. Additional fixed wings may also be provided to ...
The tail rotor is a smaller rotor mounted so that it rotates vertically or near-vertically at the end of the tail of a traditional single-rotor helicopter. The tail rotor's position and distance from the center of gravity allow it to develop thrust in a direction opposite that of the main rotor's rotation, thereby countering the torque effect ...
A coaxial-rotor aircraft is an aircraft whose rotors are mounted one above the other on concentric shafts, with the same axis of rotation, but turning in opposite directions (contra-rotating). This rotor configuration is a feature of helicopters produced by the Russian Kamov helicopter design bureau .
Below, the helicopter rotor has lost power, and the craft is making an emergency landing. Autorotation is a state of flight in which the main rotor system of a helicopter or other rotary-wing aircraft turns by the action of air moving up through the rotor, as with an autogyro, rather than engine power driving the rotor.
The wing, horizontal stabilizer, vertical stabilizer and propeller/rotor blades of an aircraft are all based on aerofoil sections, and the term chord or chord length is also used to describe their width. The chord of a wing, stabilizer and propeller is determined by measuring the distance between leading and trailing edges in the direction of ...
The wing is designed so that the angle of incidence is greater at the wing roots and decreases across the span, becoming lowest at the wing tip. This is usually to ensure that at stall speed the wing root stalls before the wing tips , providing the aircraft with continued aileron control and some resistance to spinning .
A tiltrotor is an aircraft that generates lift and propulsion by way of one or more powered rotors (sometimes called proprotors) mounted on rotating shafts or nacelles usually at the ends of a fixed wing. Almost all tiltrotors use a transverse rotor design, with a few exceptions that use other multirotor layouts.