Search results
Results From The WOW.Com Content Network
Link-local addresses are typically assigned automatically through a process known as link-local address autoconfiguration, [1] also known as auto-IP, automatic private IP addressing (APIPA, specific to IPv4), and stateless address autoconfiguration (SLAAC, specific to IPv6).
Once a unique link-local address is established, the IPv6 host determines whether the LAN is connected on this link to any router interface that supports IPv6. It does so by sending out an ICMPv6 router solicitation message to the all-routers [44] multicast group with its link-local address as source. If there is no answer after a predetermined ...
Link-local addresses and the loopback address have link-local scope, which means they can only be used on a single directly attached network. All other addresses (including unique local addresses ) have global (or universal ) scope, which means they are potentially globally routable and can be used to connect to addresses with global scope ...
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [2] (routable only within the scope of private networks, but not the global IPv6 Internet).
Interface-local Packets with this destination address may not be sent over any network link, but must remain within the current node; this is the multicast equivalent of the unicast loopback address. ffx2::/16: 224.0.0.0/24: Link-local Packets with this destination address may not be routed anywhere. ffx3::/16: 239.255.0.0/16: Realm-Local scope ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.