Search results
Results From The WOW.Com Content Network
A camshaft operating two valves. A camshaft is a shaft that contains a row of pointed cams in order to convert rotational motion to reciprocating motion.Camshafts are used in piston engines (to operate the intake and exhaust valves), [1] [2] mechanically controlled ignition systems and early electric motor speed controllers.
The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s and compared to timing chains are less expensive, smaller, lighter, quieter ...
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.
A cam engine is a reciprocating engine where instead of the conventional crankshaft, the pistons deliver their force to a cam that is then caused to rotate. The output work of the engine is driven by this cam. [1] A variation of the cam engine, the swashplate engine (also the closely related wobble-plate engine), was briefly popular. [2]
The cams open (lift) the valves kind for a certain amount of time (duration) during each intake and exhaust cycle. The timing of the valve opening and closing, relative to the position of the crankshaft, is important. The camshaft is driven by the crankshaft through timing belts, gears or chains.
This page was last edited on 5 February 2021, at 04:02 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Intake, induction or suction: The intake valves are open as a result of the cam lobe pressing down on the valve stem. The piston moves downward increasing the volume of the combustion chamber and allowing air to enter in the case of a CI engine or an air-fuel mix in the case of SI engines that do not use direct injection .