Ads
related to: mercury light bulbs clean up
Search results
Results From The WOW.Com Content Network
Fluorescent bulbs contain mercury, a toxic substance. The United States Environmental Protection Agency (EPA) provides safety guidelines for how to clean up a broken fluorescent bulb. [17] Mercury can be harmful to children and developing fetuses, so children and pregnant women should avoid being in the area whilst a broken bulb is cleaned up. [18]
A broken fluorescent tube will release its mercury content. Safe cleanup of broken fluorescent bulbs differs from cleanup of conventional broken glass or incandescent bulbs, avoiding the use of vacuum cleaners, in favour of sticky tape to recover small particles, and ensuring that fans and air conditioning are turned off.
EPA workers clean up residential mercury spill in 2004. Mercury thermometers and mercury light bulbs are not as common as they used to be, and the amount of mercury they contain is unlikely to be a health concern if handled carefully.
Despite following EPA best-practice clean-up guidelines on broken CFLs, researchers were unable to remove mercury from carpet, and agitation of the carpet — such as by young children playing — created localized concentrations as high as 0.025 mg/m 3 in air close to the carpet, even weeks after the initial breakage. [88]
Too low mercury pressure leads to too few atoms present to get ionized and radiate photons. The optimum temperature for low-pressure mercury lamps is at about 42 °C, when the saturated vapor pressure of mercury (present as a drop of about 1 mg of liquid mercury in the tube, as a reservoir compensating for losses by clean-up) reaches this optimum.
A household hazardous waste collection center in Seattle, Washington, U.S.. Under United States environmental policy, hazardous waste is a waste (usually a solid waste) that has the potential to:
Typical high-pressure bulb. Note the small specks, which are mercury droplets. This is the more common 400W "clip in" or ceramic style. High-pressure bulbs are 3 to 5 inches long and typically powered by a ballast with 250 to 2,000 watts. The most common is the 400 watt variety that is used as an added face tanner in the traditional tanning bed.
A 175-watt mercury-vapor light approximately 15 seconds after starting. A closeup of a 175-W mercury-vapor lamp. The small diagonal cylinder at the bottom of the arc tube is a resistor which supplies current to the starter electrode. A mercury-vapor lamp is a gas-discharge lamp that uses an electric arc through vaporized mercury to produce ...