Search results
Results From The WOW.Com Content Network
User segments can have users' systems connected to them. Link segments (FOIRL, 10BASE-T, 10BASE-FL, or 10BASE-FB) are used to connect the network's repeaters together. The rule mandates that there can only be a maximum of five segments, connected through four repeaters, or repeater hubs, and only three of the five segments may be mixing ...
The routing metric used by RIP counts the number of routers that need to be passed to reach a destination IP network. The hop count 0 denotes a network that is directly connected to the router. 16 hops denote a network that is unreachable, according to the RIP hop limit. [4]
In wired networks, the hop count refers to the number of networks or network devices through which data passes between source and destination (depending on routing protocol, this may include the source/destination, that is, the first hop is counted as hop 0 or hop 1 [1]). Thus, hop count is a rough measure of distance between two hosts.
The maximum practical number of nodes that can be connected to a 10BASE2 segment is limited to 30 [4] with a minimum distance of 0.5 metres (20 in) between devices. [5] In a 10BASE2 network, each stretch of cable is connected to the transceiver (which is usually built into the network adaptor) using a BNC T-connector , [ a ] with one stretch ...
Classful network design allowed for a larger number of individual network assignments and fine-grained subnetwork design. The first three bits of the most significant octet of an IP address were defined as the class of the address. Three classes (A, B, and C) were defined for universal unicast addressing. Depending on the class derived, the ...
In computer networking, the maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single network layer transaction. [ 1 ] : 25 The MTU relates to, but is not identical to the maximum frame size that can be transported on the data link layer , e.g., Ethernet frame .
The WAN PHY operates at a slightly slower data-rate than the local area network (LAN) PHY. The WAN PHY can drive maximum link distances up to 80 km depending on the fiber standard employed. The WAN PHY uses the same 10GBASE-S, 10GBASE-L and 10GBASE-E optical PMDs as the LAN PHYs and is designated as 10GBASE-SW, 10GBASE-LW or 10GBASE-EW.
Under IEEE 802.1Q, the maximum number of VLANs on a given Ethernet network is 4,094 (4,096 values provided by the 12-bit VID field minus reserved values at each end of the range, 0 and 4,095). This does not impose the same limit on the number of IP subnets in such a network since a single VLAN can contain multiple IP subnets.