Search results
Results From The WOW.Com Content Network
degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a minute. Therefore, to convert from a degrees minutes seconds format to a decimal degrees format, one may use the formula
Latitude and longitude should be displayed by sexagesimal fractions (i.e. minutes and seconds). When minutes and seconds are less than ten, leading zeroes should be shown. Degree, minutes and seconds should be followed by the symbols ° ( U+00B0 ), ′ ( U+2032 ), and ″ ( U+2033 ), without spaces between the number and symbol.
Degrees, minutes and seconds, when used, must each be separated by a pipe ("|"). Map datum must be WGS84 if possible (except for off-Earth bodies). Avoid excessive precision (0.0001° is <11 m, 1″ is <31 m). Maintain consistency of decimal places or minutes/seconds between latitude and longitude. Latitude (N/S) must appear before longitude (E/W).
Each degree of longitude is sub-divided into 60 minutes, each of which is divided into 60 seconds. A longitude is thus specified in sexagesimal notation as, for example, 23° 27′ 30″ E. For higher precision, the seconds are specified with a decimal fraction. An alternative representation uses degrees and minutes, and parts of a minute are ...
This notation leads to the modern signs for degrees, minutes, and seconds. The same minute and second nomenclature is also used for units of time, and the modern notation for time with hours, minutes, and seconds written in decimal and separated from each other by colons may be interpreted as a form of sexagesimal notation.
[9] [failed verification] Each degree was subdivided into 60 minutes and each minute into 60 seconds. [10] [11] Thus, one Babylonian degree was equal to four minutes in modern terminology, one Babylonian minute to four modern seconds, and one Babylonian second to 1 / 15 (approximately 0.067) of a modern second.
Decimal degrees are an alternative to using sexagesimal degrees (degrees, minutes, and seconds - DMS notation). As with latitude and longitude, the values are bounded by ±90° and ±180° respectively. Positive latitudes are north of the equator, negative latitudes are south of the equator.
Cities must be specified with a precision of degrees, minutes and seconds to respect historical norms. When the #Which coordinates to use guideline is used, degrees, minutes and seconds or d.dddd are the default. To specify a particular point in the city, such as a building, generally requires precision down to degrees-minutes-seconds or d.dddd ...