Ads
related to: convert dually to single wide rear wheel
Search results
Results From The WOW.Com Content Network
Busette, developed by Wayne Corporation in 1972, was the first successful small school bus to be based on a cutaway van chassis with dual rear wheels. With a low center of gravity and the dual rear wheels, Busette provided a combination of increased seating capacity and handling stability over conventional vans and van conversions.
This means: If only the front wheels are steered, the rearmost part of the formula can be left out. The most common example is probably the 4×4 configuration. 6×4*4 is the chassis configuration for a vehicle with six wheels where four wheels are driven, in addition, the two front wheels as well as the rearmost two wheels are steered.
The F-250 and F-350 single-rear-wheel versions were fitted with a 10.5-inch (270 mm) Sterling 10.5 35-spline axle with choices of conventional or limited-slip differentials; initially developed for previous-generation Ford trucks, it was strengthened for use in the Super Duty. In dual-rear-wheel F-350s, the rear axle was a Dana 80.
The excess power is transferred to the rear motor where it can be used immediately. The opposite applies when braking, when the front motor can accept more regenerative braking torque and power. [2] However dual-motor vehicles usually have less range for the same battery size than single-motor designs. [3]
RMR layout; the engine is located in front of the rear axle. Rear Mid-engine transversely-mounted / Rear-wheel drive. In automotive design, an RMR, or rear mid-engine, rear-wheel-drive layout is one in which the rear wheels are driven by an engine placed with its center of gravity in front of the rear axle, and thus right behind the passenger compartment.
Rear-wheel drive (RWD) is a form of engine and transmission layout used in motor vehicles, in which the engine drives the rear wheels only. Until the late 20th century, rear-wheel drive was the most common configuration for cars. Most rear-wheel drive vehicles feature a longitudinally-mounted engine at the front of the car.
Concept (top view): In a vehicle, motors M1 through M4 drive respective wheels independently, possibly through respective gear arrangements. Individual-wheel drive (IWD) is an automobile design in which the vehicle has an all-wheel drive powertrain that consists of multiple independent traction motors each supplying torque to a single drive wheel. [1]
The earliest example of the form appeared in 1932, with the design and construction of the prototype Maroon Car by chief designer Harleigh Holmes at Coleman Motors, an established builder of Front- and All-Wheel-Drive vehicles based in Littleton, Colorado. [1] The car had front-wheel drive and was powered by a rear-mounted V-8 engine.