Ads
related to: optic multimode fiber
Search results
Results From The WOW.Com Content Network
The equipment used for communications over multi-mode optical fiber is less expensive than that for single-mode optical fiber. [1] Typical transmission speed and distance limits are 100 Mbit/s for distances up to 2 km (), 1 Gbit/s up to 1000 m, and 10 Gbit/s up to 550 m.
Extrinsic fiber optic sensors use an optical fiber cable, normally a multi-mode one, to transmit modulated light from either a non-fiber optical sensor—or an electronic sensor connected to an optical transmitter. A major benefit of extrinsic sensors is their ability to reach otherwise inaccessible places.
A multi-mode optical fiber has a larger core (≥ 50 micrometers), allowing less precise, cheaper transmitters and receivers to connect to it as well as cheaper connectors. However, a multi-mode fiber introduces multimode distortion , which often limits the bandwidth and length of the link.
If multimode fiber bandwidth is measured using a laser diode directly coupled to its input, the resulting measurement can vary by as much as an order of magnitude. This measurement variability is due to the combination of differences in laser output characteristics (emitted mode power distribution) and the differential mode delay of the fiber.
In multimode fibre optics, mandrel wrapping is a technique used to preferentially attenuate high-order mode power of a propagating optical signal. Consequently, if the fibre is propagating substantial energy in affected modes, the modal distribution will be changed.
Most WDM systems operate on single-mode optical fiber cables which have a core diameter of 9 μm. Certain forms of WDM can also be used in multi-mode optical fiber cables (also known as premises cables) which have core diameters of 50 or 62.5 μm. Early WDM systems were expensive and complicated to run.
Ads
related to: optic multimode fiber