Ad
related to: altec lansing speakers wiring diagram 8 ohms switch
Search results
Results From The WOW.Com Content Network
The permanent magnet upgrade of the 601 was released in 1944 as the 604, at which point the 601 was discontinued. [5] The 604 was the same basic design using a 15-inch LF driver, but with a larger 3" voice coil, individual Alnico V magnets for the LF and HF drivers, and a cast aluminum frame.
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
James Bullough Lansing worked for Altec Lansing, then in 1946 he left to found the James B. Lansing Company , another manufacturer of high-quality professional loudspeakers, which competed with Altec Lansing. [12] Altec Lansing produced a line of professional and high-fidelity audio equipment, starting with a line of horn-based loudspeaker systems.
A horn-loaded speaker can have a sensitivity as high as 110 dB at 2.83 volts (1 watt at 8 ohms) at 1 meter. This is a hundredfold increase in output compared to a speaker rated at 90 dB sensitivity and is invaluable in applications where high sound levels are required or amplifier power is limited.
[citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
A coaxial loudspeaker is a loudspeaker system in which the individual driver units radiate sound from the same point or axis. Two general types exist: one is a compact design using two or three speaker drivers, usually in car audio, and the other is a two-way high-power design for professional audio, also known as single-source or dual-concentric loudspeakers. [1]