Search results
Results From The WOW.Com Content Network
Electrostatic discharge (ESD) is a subclass of electrical overstress and may cause immediate device failure, permanent parameter shifts and latent damage causing increased degradation rate. It has at least one of three components, localized heat generation, high current density and high electric field gradient; prolonged presence of currents of ...
In an electric power system, a fault or fault current is any abnormal electric current. For example, a short circuit is a fault in which a live wire touches a neutral or ground wire. An open-circuit fault occurs if a circuit is interrupted by a failure of a current-carrying wire (phase or neutral) or a blown fuse or circuit breaker.
Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network. The objective of a protection scheme is to keep the power system stable by isolating only the components ...
For example, a failure mode might be listed on the FMEA worksheet as “Pin A shorts Pin K,” and the corresponding local level failure effect might be “Input Signal X shorts Signal Y normal path.” (Here, bent Pin A carries Signal X and undamaged Pin K carries Signal Y.) Note that the failure mode “Pin A shorts Pin K” is very different ...
CAF commonly occurs between adjacent vias (i.e. plated through holes) inside a PCB, as the copper migrates along the glass/resin interface from anode to cathode.CAF failures can manifest as current leakage, intermittent electrical shorts, and even dielectric breakdown between conductors in printed circuit boards. [3]
In addition to a circuit analysis, a WCCA often includes stress and derating analysis, failure modes and effects criticality and reliability prediction . The specific objective is to verify that the design is robust enough to provide operation which meets the system performance specification over design life under worst-case conditions and ...
In electronics and electrical engineering, a fuse is an electrical safety device that operates to provide overcurrent protection of an electrical circuit. Its essential component is a metal wire or strip that melts when too much current flows through it, thereby stopping or interrupting the current.
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...