Ads
related to: component cables box covers home depot bubble paper for crafts suppliesscrapbook.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
With some cables the individual conductors are wrapped in paper before the plastic jacket is applied. Special versions of non-metallic sheathed cables, such as US Type UF, are designed for direct underground burial (often with separate mechanical protection) or exterior use where exposure to ultraviolet radiation (UV) is a possibility. These ...
The telephone cables have a large number of conductors that are individually insulated. The paper needs to be thin (30-40 g/m 2). A normal power cable needs more insulation and therefore paper with higher paper density is used, normally 60-190 g/m 2. The paper needs to be strong, elastic, uniform and free of holes or debris.
A network card inside an antistatic bag. A pink static dissipative bag, and a silver conductive bag. Note the two recurring ESD symbols. An antistatic bag is a bag used for storing electronic components, which are prone to damage caused by electrostatic discharge (ESD).
Some types of conduit are approved for direct encasement in concrete. This is commonly used in commercial buildings to allow electrical and communication outlets to be installed in the middle of large open areas. For example, retail display cases and open-office areas use floor-mounted conduit boxes to connect power and communications cables.
A power cable is an electrical cable, an assembly of one or more electrical conductors, usually held together with an overall sheath. The assembly is used for transmission of electrical power . Power cables may be installed as permanent wiring within buildings, buried in the ground, run overhead, or exposed.