When.com Web Search

  1. Ads

    related to: 4 ohm or 2 subwoofer cable

Search results

  1. Results From The WOW.Com Content Network
  2. Speakon connector - Wikipedia

    en.wikipedia.org/wiki/Speakon_connector

    Speakon panel connectors (center) provided on a professional PA power amplifier by QSC with a power output of 2 x 700 Watt (4 Ohm) The Speakon (stylized speakON) is a trademarked name for an electrical connector, [2] originally manufactured by Neutrik, mostly used in professional audio systems for connecting loudspeakers to amplifiers.

  3. Speaker wire - Wikipedia

    en.wikipedia.org/wiki/Speaker_wire

    Ordinary lamp cord has an inductance of 0.1–0.2 μH/ft, likewise for shielded cord, [6] so a run of up to about 10 feet (20 total feet of conductor) will have less than 1% inductive loss in the audible range (10 ft * 0.2 μH/ft = 2.0 μH, which is at or below the proximate threshold of 2 μH given above). Some premium speaker cables have ...

  4. Electrical characteristics of dynamic loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Electrical_characteristics...

    Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.

  5. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal voltages. The result will be very weak sound from the speaker and possibly a damaged line out circuit.

  6. Sound reinforcement system - Wikipedia

    en.wikipedia.org/wiki/Sound_reinforcement_system

    Three audio power amplifiers Rear panel of a power amplifier with 2 × 700 Watt (4 Ohm) - very similar to the topmost device in the image above - showing typical connectors for professional use: From left, symmetrical XLR-sockets for signal input, alternatively audio jack sockets, loudspeaker terminals of type Speakon (center), alternatively ...

  7. Linn Isobarik - Wikipedia

    en.wikipedia.org/wiki/Linn_Isobarik

    This 2-way, 4-ohm, design was a physically much smaller product – measuring 425 × 332 × 244 mm (16.7 × 13.1 × 9.6 in) – that required tall speaker stands. Launched in 1978, it was Linn's entry-level loudspeaker until the Kan (a non-isobaric bookshelf speaker using the same Linn D20-LP-1 and KEF B110 drive units as its big brother) was ...