Ads
related to: attic fan temperature control switch behind knob assembly diagram
Search results
Results From The WOW.Com Content Network
Typical fan heater's internal parts. The picture immediately to the right (the top on the mobile site) shows most of the component parts of a typical plug-in electric fan heater. The heating element is the coiled wire frame located behind the fan blades. The thermostat is at the top left. The heat (wattage) selector switch is at the top right.
An attic fan installed underneath a roof. A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional ...
Two control knobs for a heating/cooling system. The left knob controls the temperature while the right controls the fan speed. A control knob is a rotary device used to provide manual input adjustments to a mechanical/electrical system when grasped and turned by a human operator, so that differing extent of knob rotation corresponds to different desired input.
Knob-and-tube wiring may also be damaged by building renovations. [11] Its cloth and rubber insulation can dry out and turn brittle. [ 10 ] It may also be damaged by rodents and careless activities such as hanging objects from wiring running in accessible areas like basements or attics.
HVAC (Heating, Ventilation and Air Conditioning) equipment needs a control system to regulate the operation of a heating and/or air conditioning system. [1] Usually a sensing device is used to compare the actual state (e.g. temperature) with a target state. Then the control system draws a conclusion what action has to be taken (e.g. start the ...
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible.A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator.
The earliest standardized method of wiring in buildings, in common use in North America from about 1880 to the 1930s, was knob and tube (K&T) wiring: single conductors were run through cavities between the structural members in walls and ceilings, with ceramic tubes forming protective channels through joists and ceramic knobs attached to the ...
A household electric fan A large cylindrical fan. A fan is a powered machine that creates airflow. A fan consists of rotating vanes or blades, generally made of wood, plastic, or metal, which act on the air. The rotating assembly of blades and hub is known as an impeller, rotor, or runner.