Search results
Results From The WOW.Com Content Network
deRFmega128-22M00 2.4 GHz ATmega128RFA1 8-bit ATmega 16 kB 128 kB Chip ceramic antenna < 1 μA 18 mA 18 mA +3 dBm -98 dBm 23.6 mm × 13.2 mm × 3.0 mm 2012 JTAG, UART, I²C, ADC, SPI, GPIO: MAC stack Zigbee (BitCloud) 6LoWPAN Atmel deRFmega128-22M10 2.4 GHz RF pads 19.0 mm × 13.2 mm × 3.0 mm deRFmega128-22M12 2.4 GHz 198 mA
A push-pull amplifier will have fewer harmonics than a single ended circuit. A class A amplifier will have very few harmonics, class AB or B more, and class C the most. In the typical class C amplifier, the resonant tank circuit will remove most of the harmonics, but in either of these examples, a low pass filter will likely be needed following ...
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
The loss in that feed line is 3.2 dB at 1 GHz; approximately 5 dB at the GPS frequency (1.575 42 GHz). This feed line loss can be avoided by placing an LNA at the antenna, which supplies enough gain to offset the loss. An LNA is a key component at the front-end of a radio receiver circuit to help reduce unwanted noise in particular.
Commercial FM broadcasting transmitter at radio station WDET-FM, Wayne State University, Detroit, US.It broadcasts at 101.9 MHz with a radiated power of 48 kW.. In electronics and telecommunications, a radio transmitter or just transmitter (often abbreviated as XMTR or TX in technical documents) is an electronic device which produces radio waves with an antenna with the purpose of signal ...
The 13 centimeter, 2.3 GHz or 2.4 GHz band is a portion of the UHF radio spectrum internationally allocated to amateur radio and amateur satellite use on a secondary basis. The amateur radio band is between 2300 MHz and 2450 MHz, and thereby inside the S-band. The amateur satellite band is between 2400 MHz and 2450 MHz, and its use by satellite ...
IEEE 802.11n is an amendment to IEEE 802.11-2007 as amended by IEEE 802.11k-2008, IEEE 802.11r-2008, IEEE 802.11y-2008, and IEEE 802.11w-2009, and builds on previous 802.11 standards by adding a multiple-input multiple-output (MIMO) system and 40 MHz channels to the PHY (physical layer) and frame aggregation to the MAC layer.
A 3 dB 2.0–4.2 GHz power divider/combiner. Power dividers (also power splitters and, when used in reverse, power combiners) and directional couplers are passive devices used mostly in the field of radio technology. They couple a defined amount of the electromagnetic power in a transmission line to a port enabling the signal to be used in ...