Ads
related to: weight of 2x6 lumber per foot table in mm height conversion
Search results
Results From The WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters .
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.
Finger-jointed lumber – solid dimensional lumber lengths typically are limited to lengths of 22 to 24 feet (6.7–7.3 m), but can be made longer by the technique of "finger-jointing" by using small solid pieces, usually 18 to 24 inches (460–610 mm) long, and joining them together using finger joints and glue to produce lengths that can be ...
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples:
US spelling: meter per second: 1.0 m/s (3.3 ft/s) m/s ft/s (m/s foot/s) non-SI metric: kilometre per hour: km/h km/h US spelling: kilometer per hour: 1.0 km/h (0.62 mph) km/h mph; Imperial & US customary: mile per hour: mph mph 1.0 mph (1.6 km/h) mph km/h; mph kn; foot per second: ft/s (foot/s) ft/s long code "foot/s" outputs foot per second ...
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.
The most common dimension is 1.2 by 2.4 metres (3 ft 11 in × 7 ft 10 in) or the slightly larger imperial dimension of 4 feet × 8 feet. Plies vary in thickness from 1.4 mm to 4.3 mm. The number of plies—which is always odd—depends on the thickness and grade of the sheet. Roofing can use the thinner 16-millimetre (5 ⁄ 8 in) plywood.