Search results
Results From The WOW.Com Content Network
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
The term is most commonly associated with data networking to describe the capability of a network to 'route around' damage, such as loss of a node or a connection between nodes, as long as other path choices are available. [4] Dynamic routing allows as many routes as possible to remain valid in response to the change.
When a multicast packet enters a router's interface, the router looks up the list of networks that are reachable via that interface (i.e., it checks the paths by which the packet could have arrived). If the router finds a matching routing entry for the source IP address of the multicast packet, the RPF check passes and the packet is forwarded ...
In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. [1] The IP forwarding algorithm states: [2] Given a destination IP address, D, and network prefix, N:
The Berkeley r-commands are a suite of computer programs designed to enable users of one Unix system to log in or issue commands to another Unix computer via TCP/IP computer network. [1] The r-commands were developed in 1982 by the Computer Systems Research Group at the University of California, Berkeley , based on an early implementation of ...
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
In computer networking, source routing, also called path addressing, allows a sender of a data packet to partially or completely specify the route the packet takes through the network. [1] In contrast, in conventional routing , routers in the network determine the path incrementally based on the packet's destination.
Multi-path routing can be used in conjunction with most routing protocols because it is a per-hop local decision made independently at each router. It can substantially increase bandwidth by load-balancing traffic over multiple paths; however, there may be significant problems in deploying it in practice.