Ad
related to: jasper 390 big block dyno
Search results
Results From The WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
It used a new 4.13-inch (104.90 mm) bore with the 390's 3.785-inch (96.14 mm) stroke, giving a displacement of 405.7 cu in (6.6 L), rounded up to "406" for the official designation. The larger bore required a new block casting design allowing for thicker walls, but otherwise was very similar to the 390 block. [20]
Cylinder block material: Cast iron: Cylinder head material: Cast iron: Valvetrain: Cam-in-block 2 (B-Series) or 4 (ISB, QSB) valves/cylinder: Compression ratio: 17.2:1, 17.3:1, 17.5:1, 19:1: Combustion; Turbocharger: Holset Engineering (variable) Fuel system: Common rail high pressure direct injection, symmetrical combustion chamber with 7-hole ...
Other than that, this engine is vastly different from the Gen-1 model. The Gen-1 engine is physically the size of a big-block Ford or GM engine, and is sometimes called a "big-block". The Gen-2 is closer to the physical size of U.S.-made small-block V8s except for the bore centers, which are the same as some big-block engines.
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
For the 1978 model year, Pontiac re-incorporated the earlier thicker cast cast engine block denoted by the cast number 418988 and a "XX" cast into the side of the block. The earlier 1975-78 blocks had metal shaved from the journals and bottom end as well as a decrease in the nickel content of the block in an attempt to decrease the overall ...
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...