Search results
Results From The WOW.Com Content Network
An elaborate Celtic scabbard of 1-200 AD, in two colours of bronze 1916 Leather Scabbard for a saddle lever-action rifle of Jack Peters, a ranch hand that worked on the Grant-Kohrs Ranch, in Powell County, Montana. A scabbard is a sheath for holding a sword, dagger, knife, or similar edged weapons.
The scabbard itself was typically made of wood or leather, and the inside was often lined with fleece or fur. The inside might have also been greased or oiled to prevent the sword from rusting. [44] Some scabbards were further protected by a metal binding at their neck (known as a frog or locket) and a chape at the bottom. [45]
The entrenching tool helve and bayonet scabbard can also be seen. The 1908 equipment, when fully assembled, formed a single piece, and could be put on or taken off like a jacket. Ammunition was stored in two sets of pouches attached to the belt at the front, and the straps from these passed over the shoulders, crossing diagonally at the back.
British Pattern 1912 cavalry officer's sword with dress and field service scabbards British Pattern 1912 officer's sword hilt. Whereas swords for troopers and NCOs were issued by the Army, officer's swords were privately purchased by the officers themselves. Until 1912, officers continued to carry their pierced "honeysuckle" hilted or three-bar ...
The Pattern 1907 bayonet was supplied with a simple leather scabbard fitted with a steel top-mount and chape, and usually carried from the belt by a simple frog. The Pattern 1907 bayonet attaches to the SMLE by a boss located below the barrel on the nose of the rifle and a mortise groove on the pommel of the bayonet. [2] [4]
The M1910 scabbard was covered in canvas with a leather tip to prevent the blade tip from tearing the material. A wire hook that engaged grommets on the cartridge belt replaced the belt-hanger. The M1910 scabbard was the primary scabbard used during the World War I. Earlier M1905 scabbards were modified by replacing the belt-hanger with a belt ...
The scabbard was made of steel, hanging from a leather strap, and was 22.7 cm long. A total of 101750 [27] was manufactured by Kongsberg Våpenfabrikk, Husqvarna and Steyr. Bayonet M/1912 was constructed during the development of the "short rifle" that became the M1912 carbine. It was significantly longer than the M/1894, to maintain the "reach ...
The leather also tended to deteriorate during long periods in the field. After the war, review of the British Army's performance was conducted by the 1903 Royal Commission on the War in South Africa, which heard evidence that the Slade–Wallace equipment was "cumbersome, heavy and badly balanced" and "an absurdity".