Search results
Results From The WOW.Com Content Network
GNOME Disks is a graphical front-end for udisks. [3] It can be used for partition management, S.M.A.R.T. monitoring, benchmarking, and software RAID (until v. 3.12). [4] An introduction is included in the GNOME Documentation Project.
df (abbreviation for disk free) is a standard Unix command used to display the amount of available disk space for file systems on which the invoking user has appropriate read access. df is typically implemented using the statfs or statvfs system calls .
If you cannot use smartctl -l scterr,x,y to set the TLER, the relevant command-line commands are openSeaChest_Configure -d /dev/sg0 --sctReadTimer and openSeaChest_Configure -d /dev/sg0 --sctWriteTimer.
dd is a command-line utility for Unix, Plan 9, Inferno, and Unix-like operating systems and beyond, the primary purpose of which is to convert and copy files. [1] On Unix, device drivers for hardware (such as hard disk drives) and special device files (such as /dev/zero and /dev/random) appear in the file system just like normal files; dd can also read and/or write from/to these files ...
-c, display a grand total of the disk usage found by the other arguments-d #, the depth at which summing should occur. -d 0 sums at the current level, -d 1 sums at the subdirectory, -d 2 at sub-subdirectories, etc.-H, calculate disk usage for link references specified on the command line-k, show sizes as multiples of 1024 bytes, not 512-byte
The chkdsk command on Windows XP. CHKDSK can be run from DOS prompt, Windows Explorer, Windows Command Prompt, Windows PowerShell or Recovery Console. [10] On Windows NT operating systems, CHKDSK can also check the disk surface for bad sectors and mark them (in MS-DOS 6.x and Windows 9x, this is a task done by Microsoft ScanDisk).
Drive: This command-line argument specifies the drive letter of the disk for which to display the volume label and serial number. Note: On Windows, the volume serial number is displayed only for disks formatted with MS-DOS version 4.0 or later. OS/2 allows the user to specify more than one drive. The vol command displays the volume labels ...
UAS depends on the USB protocol, and uses the standard SCSI command set. Use of UAS generally provides faster transfers compared to the older USB Mass Storage Bulk-Only Transport (BOT) drivers. UAS was introduced as part of the USB 3.0 standard, but can also be used with devices complying with the slower USB 2.0 standard, assuming use of ...