Ads
related to: cisco inter switch link to usb 2.0
Search results
Results From The WOW.Com Content Network
The Cisco Inter-Switch Link (ISL) protocol for supporting VLANs on Ethernet and similar LAN technologies was based on IEEE 802.10; in this application 802.10 has largely been replaced by IEEE 802.1Q. The standard being developed has 8 parts: a. Model, including security management b. Secure Data Exchange (SDE) protocol c. Key Management
High-Speed Inter-Chip (HSIC) is a chip-to-chip variant of USB 2.0 that eliminates the conventional analog transceivers found in normal USB. It was adopted as a standard by the USB-IF in 2007. The HSIC physical layer uses about 50% less power and 75% less board area compared to traditional USB 2.0. HSIC uses two signals at 1.2 V and has a ...
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.