Ads
related to: siphon from lower to higher pressure valve for toilet seat cover
Search results
Results From The WOW.Com Content Network
A high-pressure valve located in the center of the vessel holds the air and water inside until the user flushes the toilet. [ 12 ] During flushing, the user activates the valve via a button or lever, which releases the pressurized water into the bowl at a flow rate much higher than a conventional gravity-flow toilet.
So the liquid flows from the higher-pressure area of the upper reservoir up to the lower-pressure zone at the top of the siphon, over the top, and then, with the help of gravity and a taller column of liquid, down to the higher-pressure zone at the exit. [2] [18]
Back-siphonage occurs when higher pressure fluids, gases, or suspended solids move to an area of lower pressure fluids. For example, when a drinking straw is used to consume a beverage, suction reduces the pressure of fluid inside the straw, causing liquid to move from the cup to inside the straw and then into the drinker's mouth.
Backflow occurs for one of two reasons, either back pressure or back siphonage. [1] Back pressure is the result of a higher pressure in the system than in its supply, i.e. the system pressure has been increased by some means. This may occur in unvented heating systems, where thermal expansion increases the pressure.
Inside this elbow is a poppet valve that is held "up" by the water pressure found in the system, closing the air entrance to the device. If the pressure in the "upstream side" is reduced to atmospheric pressure or below, the poppet valve drops and allows air to enter the system, breaking the siphon. [1]
A later innovation, the floatless fill valve, designed for low-profile, low-flow toilet tanks, uses a pressure-sensing diaphragm mechanism instead of a float to control the inlet valve. [4] Delay valves, which delay the filling until the level has dropped to a low level, avert short-cycling of the water supply.
A narrow passageway leads from the main water supply into the pressure chamber. It is the narrowness of this passage that meters the flow by slowing repressurizing of the pressure chamber after the action of a flush. The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down.
The water in the toilet bowl is connected to a pipe shaped like an upside-down U. One side of the U channel is arranged as a siphon tube longer than the water in the bowl is high. The siphon tube connects to the drain. The bottom of the drain pipe limits the height of the water in the bowl before it flows down the drain.