Ads
related to: ppm calculation formula in quality control management course free- View E-Learning Examples
Find Inspirational Slides,
Interactions, Assessments And More.
- Online Resource Center
Top resources for online training.
Explore blogs, cases, guides & more
- Free Trial
Try all apps & resources included
in Articulate 360. No obligation.
- Contact Us
Questions about Articulate?
You're in the right place.
- View E-Learning Examples
Search results
Results From The WOW.Com Content Network
= air pollutant concentration, in parts per million by volume mg/m 3 = milligrams of pollutant per cubic meter of air = atmospheric temperature in kelvins = 273.15 + °C 0.08205 = Universal Gas Law constant in atm·l/(mol·K) = molecular weight of the air pollutant (dimensionless)
1 volume percent = 10,000 ppmv (i.e., parts per million by volume) with a million being defined as 10 6. Care must be taken with the concentrations expressed as ppbv to differentiate between the British billion which is 10 12 and the USA billion which is 10 9 (also referred to as the long scale and short scale billion, respectively).
Six Sigma (6σ) is a set of techniques and tools for process improvement.It was introduced by American engineer Bill Smith while working at Motorola in 1986. [1] [2]Six Sigma strategies seek to improve manufacturing quality by identifying and removing the causes of defects and minimizing variability in manufacturing and business processes.
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
A defect can be defined as a nonconformance of a quality characteristic (e.g. strength, width, response time) to its specification. DPMO is stated in opportunities per million units for convenience: processes that are considered highly capable (e.g., processes of Six Sigma quality) are those that experience fewer than 3.4 defects per million ...
Like OSHA, Mine Safety and Health Administration (MSHA) also uses the same 5 decibel exchange rate and 90 dBA for an 8-hour TWA for their PEL. Once a miner's noise exposure exceeds the PEL, feasible engineering AND administrative controls must be in place to try to limit the noise exposure of the employees.
Consider a quality characteristic with target of 100.00 μm and upper and lower specification limits of 106.00 μm and 94.00 μm respectively. If, after carefully monitoring the process for a while, it appears that the process is in control and producing output predictably (as depicted in the run chart below), we can meaningfully estimate its ...
Fluorescein aqueous solutions, diluted from 10,000 to 1 parts-per-million in intervals of 10 fold dilution. At 1 ppm the solution is a very pale yellow. At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour.