Ad
related to: chrysler a 413 seal leak
Search results
Results From The WOW.Com Content Network
The 400 cu in (6.6 L) B engine was introduced in 1972 to replace the venerable 383, and were power-rated via the net (installed) method. Chrysler increased the bore size of the 383 to create the 400. Its bore of 4.342-inch (110.3 mm) was the largest used in any production Chrysler V8 at the date of its introduction.
The Max Wedge, formally the Maximum Performance Wedge, was an engine option produced by the Chrysler Corporation from 1962 to 1964, that was available exclusively in B Platform (intermediate) Dodges and Plymouths. The Max Wedge motor used the Chrysler RB Block, and was produced in 413 and 426 cubic
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
Chrysler Group is recalling 26,397 cars and trucks to repair power-steering hoses that may become disconnected and leak fluid, raising the potential for vehicle fires. Models involved include the ...
In an internal combustion engine, a head gasket provides the seal between the engine block and cylinder head(s). Its purpose is to seal the combustion gases within the cylinders and to avoid coolant or engine oil leaking into the cylinders. [1] Leaks in the head gasket can cause poor engine running and/or overheating.
A 1964 Rambler American with a 195.6 OHV engine. American Motors' first straight-six engine was the 196 cubic inch (195.6 cu in (3.2 L)) six produced from 1952 through 1965, initially as a flathead (L-head) side-valve, and later an overhead valve (OHV) version.
Chrysler developed its first experimental hemi engine for the Republic P-47 Thunderbolt fighter aircraft. The XIV-2220 was an inverted V16 rated at 2,500 hp (1,860 kW). The P-47 was already in production with a Pratt & Whitney radial engine when the XIV-2220 flew successfully in trials in 1945 as a possible upgrade, but the war was winding down and it did not go into production.
Chrysler Corporation used several different designs of composite material head gaskets in an attempt to solve this problem. The cause of the problem was found to be one head bolt hole that was drilled too shallow at the factory, meaning the head bolt bottomed out and could never seal properly.