Ads
related to: extra long allen wrench metric conversion tool free
Search results
Results From The WOW.Com Content Network
The tolerances necessary to make the tools usable are listed in documents such as ASME/ANSI B18.2.2 for U.S. standards. [1] For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space.
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
A hex key (also, hex wrench, Allen key and Allen wrench, Unbrako or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.
Standard 12-point hex socket bits and wrenches fit these screws. The screw heads are typically flanged, and may fit into standard Allen hex socket cap screw counterbores molded or machined into parts to be fastened. Compared to Allen hex sockets, the advantages of these bolts include higher torque capability and the lack of a recess to trap water.
Extended-reach or long-series drills are commonly called aircraft-length from their original use in manufacturing riveted aluminum aircraft. For bits thicker than a minimum size such as 1 ⁄ 8 -inch (3.175 mm), they are available in fixed lengths such as 6, 8, 12 or 18 inches (152, 203, 305 or 457 mm) rather than the progressive lengths of ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...