Search results
Results From The WOW.Com Content Network
Yield Point Elongation (YPE) significantly impacts the usability of steel. In the context of tensile testing and the engineering stress-strain curve, the Yield Point is the initial stress level, below the maximum stress, at which an increase in strain occurs without an increase in stress.
Stress–strain curve for brittle materials compared to ductile materials. Some common characteristics among the stress–strain curves can be distinguished with various groups of materials and, on this basis, to divide materials into two broad categories; namely, the ductile materials and the brittle materials. [1]: 51
The Ramberg–Osgood equation was created to describe the nonlinear relationship between stress and strain—that is, the stress–strain curve—in materials near their yield points. It is especially applicable to metals that harden with plastic deformation (see work hardening ), showing a smooth elastic-plastic transition.
As shown later in this article, at the onset of yielding, the magnitude of the shear yield stress in pure shear is √3 times lower than the tensile yield stress in the case of simple tension. Thus, we have: = where is tensile yield strength of the material. If we set the von Mises stress equal to the yield strength and combine the above ...
Yield spread – difference between the quoted rates of return on two different investments; I-spread — difference between a bond yield and an interpolation from the Treasury yield curve; Z-spread — parallel spread of a bond yield over the zero-volatility Treasury yield curve
During the propagation of the band the nominal stress–strain curve is flat. [4] After the band has passed through the material the deformation proceeds uniformly with positive strain hardening . Sometimes Lüders band transition into the Portevin–Le Chatelier effect while changing the temperature or strain rate , this implies these are ...
The difference between the Cam Clay and the Modified Cam Clay [4] (MCC) is that the yield surface of the MCC is described by an ellipse and therefore the plastic strain increment vector (which is perpendicular to the yield surface) for the largest value of the mean effective stress is horizontal, and hence no incremental deviatoric plastic ...
This is not true since the actual area will decrease while deforming due to elastic and plastic deformation. The curve based on the original cross-section and gauge length is called the engineering stress–strain curve, while the curve based on the instantaneous cross-section area and length is called the true stress–strain curve. Unless ...