Search results
Results From The WOW.Com Content Network
While shearing a bar and angle, the typical tolerance is +0.06 inch or −0.06 inch, but it is possible to get the tolerance to +0.03 inch or −0.03 inches. Surface finishes typically occur within the 250 to 1000 microinches range but can range from 125 to 2000 microinches. A secondary operation is required if one wants better surfaces than this.
microinches (μin.) (μin.) (μm) N12 50 2000 2200 2000 200 N11 25 1000 1100 1000 100 N10 12.5 500 550 500 50 N9 6.3 250 275 250 25 N8 3.2 125 137.5 125 13 N7 1.6 63 ...
A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.
A typical range of surface roughness that can be obtained without resorting to special equipment would fall in the range of 1 to 30 units Ra (average roughness), usually microinches. Surface accuracy or flatness is usually measured in units of helium light band (HLB), one HLB measuring about 280 nm (1.1 × 10 −5 in). Again, without resort to ...
Mesh is a measurement of particle size often used in determining the particle-size distribution of a granular material.For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings.
The micrometre (Commonwealth English as used by the International Bureau of Weights and Measures; [1] SI symbol: μm) or micrometer (American English), also commonly known by the non-SI term micron, [2] is a unit of length in the International System of Units (SI) equalling 1 × 10 −6 metre (SI standard prefix "micro-" = 10 −6); that is, one millionth of a metre (or one thousandth of a ...
A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils). The words are shortened forms of the English and Latin words for "thousand" (mille ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...