Ad
related to: how to check rs232 communication
Search results
Results From The WOW.Com Content Network
In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data. It formally defines signals connecting between a DTE ( data terminal equipment ) such as a computer terminal or PC , and a DCE ( data circuit-terminating equipment or data communication ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively). Thus, "software flow control" is sometimes called "XON ...
The physical hardware communications link (physical layer) is not defined by SCPI. [5] While it was originally created for the IEEE-488.1 (GPIB) bus, [5] SCPI can also be used with RS-232, RS-422, RS-485, USB, Ethernet, VXIbus, HiSLIP, etc. [5] SCPI commands are ASCII textual strings, [5] which are sent to the instrument over the physical layer ...
COM (communication port) [1] [2] is the original, yet still common, name of the serial port interface on PC-compatible computers. It can refer not only to physical ports, but also to emulated ports, such as ports created by Bluetooth or USB adapters .
Automatic baud rate detection (ABR, autobaud) refers to the process by which a receiving device (such as a modem) determines the speed, code level, start bit, and stop bits of incoming data by examining the first character, usually a preselected sign-on character on a UART connection.