Ads
related to: pulley system calculator
Search results
Results From The WOW.Com Content Network
A block and tackle [1] [2] or only tackle [3] is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift heavy loads.. The pulleys are assembled to form blocks and then blocks are paired so that one is fixed and one moves with the load.
The rope is threaded through the pulleys to provide mechanical advantage that amplifies that force applied to the rope. [4] In order to determine the mechanical advantage of a block and tackle system consider the simple case of a gun tackle, which has a single mounted, or fixed, pulley and a single movable pulley.
A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force. A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain.
Examples of rope and pulley systems illustrating mechanical advantage. Consider lifting a weight with rope and pulleys. A rope looped through a pulley attached to a fixed spot, e.g. a barn roof rafter, and attached to the weight is called a single pulley. It has a mechanical advantage (MA) = 1 (assuming frictionless bearings in the pulley ...
where is the angle (in radians) between the two flat sides of the pulley that the v-belt presses against. [5] A flat belt has an effective angle of α = π {\displaystyle \alpha =\pi } . The material of a V-belt or multi-V serpentine belt tends to wedge into the mating groove in a pulley as the load increases, improving torque transmission.
Underdrive pulleys increase engine output by reducing the draw of the engine's accessories by slowing them down and reducing the horsepower (HP) they use. Horsepower gains from underdrive pulleys can vary by vehicle, engine, number of accessories and the amount of underdrive (improvements of up to 5–15 HP at the wheels have been seen).
Belts are looped over pulleys and may have a twist between the pulleys, and the shafts need not be parallel. In a two pulley system, the belt can either drive the pulleys normally in one direction (the same if on parallel shafts), or the belt may be crossed, so that the direction of the driven shaft is reversed (the opposite direction to the ...
A dumb pulley can lift very large masses a short distance. It consists of two fixed pulleys of unequal radii that are attached to each other and rotate together, a single pulley bearing the load, and an endless rope looped around the pulleys. To avoid slippage, the rope is usually replaced by a chain, and the connected pulleys by sprockets.