When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of unusual units of measurement - Wikipedia

   en.wikipedia.org/wiki/List_of_unusual_units_of...

   One brass is exactly 100 square feet (9.29 m 2) area (used in measurement of work done or to be done, such as plastering, painting, etc.). The same word is used, however, for 100 cubic feet (2.83 m 3) of estimated or supplied loose material, such as sand, gravel, rubble, etc

3. List of conversion factors - Wikipedia

   en.wikipedia.org/wiki/List_of_conversion_factors

   pound per square foot: psf ≡ 1 lbf/ft 2: ≈ 47.880 26 Pa [33] pound per square inch: psi ≡ 1 lbf/in 2: ≈ 6.894 757 × 10 3 Pa [33] poundal per square foot: pdl/sq ft ≡ 1 pdl/sq ft ≈ 1.488 164 Pa [33] short ton per square foot: ≡ 1 short ton × g 0 / 1 sq ft ≈ 9.576 0518 × 10 4 Pa: torr: torr ≡ 101 325 ⁄ 760 Pa ≈ 133.3224 ...

4. Hoppus - Wikipedia

   en.wikipedia.org/wiki/Hoppus

   This volume measurement was developed to estimate what volume of a round log would be usable timber after processing, in effect attempting to ‘square’ the log and allow for waste. The hoppus ton (HT) was also a traditionally used unit of volume in British forestry. One hoppus ton is equal to 50 hoppus feet or 1.8027 cubic meters.

5. What’s the average square footage of a house? - AOL

   www.aol.com/finance/average-square-footage-house...

   Is 2,500 square feet considered a big house? Yes, 2,500 square feet is bigger than average. According to U.S. Census data, the average newly built single-family home in 2022 measured 2,299 square ...

6. Floor area - Wikipedia

   en.wikipedia.org/wiki/Floor_area

   Hong Kong law Chapter 123F, Building (Planning) Regulations, Regulation 23 sect 3 sub-paragraph (a) defined that: Subject to sub-paragraph (b), for the purposes of regulations 19, 20, 21 and 22, the gross floor area of a building shall be the area contained within the external walls of the building measured at each floor level (including any floor below the level of the ground), together with ...

7. Conversion of units - Wikipedia

   en.wikipedia.org/wiki/Conversion_of_units

   The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...