Ad
related to: how big is 5/16 in diameter
Search results
Results From The WOW.Com Content Network
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
The French scale measures the outer diameter of the catheter, not the size of the internal drainage channel (inner diameter). For instance, a two-way catheter of 20 Fr and a three-way catheter of 20 Fr have the same outer diameter, but the three-way catheter has an additional channel for irrigation, reducing the size of its drainage channel.
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]
Although such information contains long lists of sieve sizes, in practice sieves are normally used in series in which each member sieve is selected to pass particles approximately 1/ √ 2 smaller in diameter or 1/2 smaller in cross-sectional area than the previous sieve. For example the series 80mm, 63, 40, 31.5, 20, 16, 14, 10, 8, 6.3, 4, 2.8 ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
1.0 mm – diameter of a pinhead; 1.5 mm – average length of a flea [27] 2.54 mm – distance between pins on old dual in-line package (DIP) electronic components; 5 mm – length of an average red ant; 5 mm – diameter of an average grain of rice; 5.56×45mm NATO – standard ammunition size; 6 mm – approximate width of a pencil
A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.
In bolts the number refers to the diameter of the bolt whereas in a fitting it refers to the OD of the tube and thereby have different threads. For example, AN6 bolt has a 3 ⁄ 8 -24 thread [ 3 ] whereas an -6 AN fitting has a 9 ⁄ 16 -18 thread.