Search results
Results From The WOW.Com Content Network
Setting non-AHCI mode (i.e. IDE or Combined mode) in the BIOS will allow the user to boot into Windows, and thereby the required registry change can be performed. Consequently, the user then has the option of continuing to use the system in Combined mode or switching to AHCI mode. [8]
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
In BIOS mode the legacy/BIOS booting is under CSMCORE. In true UEFI mode the RST is controlled under SataDriver / RstVmdDriver in BIOS. The Intel RAID ROM is the firmware in the motherboard BIOS that is used to create the RAID array. Note: The RST drivers can be used for RAID and also on a single drive as it contains an AHCI driver.
Higher end version of 915. Supports another PAT-like mode and ECC memory, and exclusively uses DDR-II RAM. Sub-versions: 925XE - Supports a 1066 MT/s bus. 945P (Lakeport) Update on 915P, with support for Serial ATA II, RAID mode 5, an improved memory controller with support for DDR-II at 667 MHz and additional PCI Express lanes.
[4] [5] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller support was not present during their initial install.
A Serial ATA port multiplier is a unilateral splitting device. While it allows one equipped port to connect up to 15 disks, the bandwidth available is limited to the bandwidth of the link to the controller, as of 2012 1.5, 3, or 6 Gbit/s. [3]
It is confirmed that with native Microsoft drivers the TRIM command works on Windows 7 in AHCI and legacy IDE / ATA Mode. [44] Windows 8 and later Windows operating systems support the unmap command for devices that use the SCSI driver stack, including USB Attached SCSI Protocol (UASP).
ICH - 82801AA. The first version of the ICH was released in June 1999 along with the Intel 810 northbridge.While its predecessor, the PIIX, was connected to the northbridge through an internal PCI bus with a bandwidth of 133 MB/s, the ICH used a proprietary interface (called by Intel Hub Interface) that linked it to the northbridge through an 8-bit wide, 266 MB/s bus.