Search results
Results From The WOW.Com Content Network
The most common size category. For women of about average height (5 ft 4 in) with an average bust height and an hourglass figure. Dress sizes may be given as girth at the bust in inches (e.g., 36), but even-numbered sizes from 2 to 16 are more common. Categorical sizes range from XS (extra-small) to XL (extra-large). Junior sizes
The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]
Instead, the label should show the range of body dimensions from half the step size below to half the step size above the design size (e.g., "height: 172–180 cm."). For heights, for example, the standard recommends generally to use the following design dimensions, with a step size of 8 cm:
There are anecdotal objections to the use of metric units in carpentry and the building trades, on the basis that it is easier to remember an integer number of inches plus a fraction, rather than a measurement in millimeters, [9] or that foot-inch measurements are more suitable when distances are frequently divided into halves, thirds, and ...
(For example: jeans label stating inner leg length of the jeans in centimetres or inches (not inner leg measurement of the intended wearer).) Ad hoc sizes: The label states a size number or code with no obvious relationship to any measurement. (For example: Size 12, XL.)
1.63 m – (5 feet 4 inches) (or 64 inches) – height of average U.S. female human as of 2002 (source: U.S. Centers for Disease Control and Prevention (CDC)) 1.75 m – (5 feet 8 inches) – height of average U.S. male human as of 2002 (source: U.S. CDC as per female above) 2.4 m – wingspan of a mute swan
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
In this instrument, a small, precise rack and pinion drives a pointer on a circular dial, allowing direct reading without the need to read a vernier scale. Typically, the pointer rotates once every inch, tenth of an inch, or 1 millimeter. This measurement must be added to the coarse whole inches or centimeters read from the slide.