Search results
Results From The WOW.Com Content Network
Steel studs are gaining popularity as a non-combustible alternative, especially for non load-bearing walls, and are required in some firewalls. In New Zealand, the required lumber size and spacing of wall studs are determined using NZS 3604 Timber-framed buildings table 8.2 for loadbearing walls and table 8.4 for non-loadbearing walls. [4]
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...
Wood furring strips typically measure 1 x 2 or 1 x 3 inches. They can be laid out perpendicular to studs or joists and nailed to them, or set vertically against an existing wall surface. The spacing between the strips depends on the type of finishing material. Wider spacing is typically used behind the heavy boards that support ceramic tiles.
In modern wood construction, sills usually come in sizes of 2×4, 2×6, 2×8, and 2×10. In stick framing, the sill is made of treated lumber, and is anchored to the foundation wall, often with J-bolts, to keep the building from coming off the foundation during a severe storm or earthquake. Building codes require that the bottom of the sill ...
Timber-framed structures differ from conventional wood-framed buildings in several ways. Timber framing uses fewer, larger wooden members, commonly timbers in the range of 15 to 30 cm (6 to 12 in), while common wood framing uses many more timbers with dimensions usually in the 5- to 25-cm (2- to 10-in) range.
[citation needed] PSL can be made from any wood species, but Douglas fir, southern pine, western hemlock, and yellow poplar are commonly chosen [9] because of their superior strength. The product is manufactured as a 12-by-12-inch (300 mm × 300 mm) or 12-by-18-inch (300 mm × 460 mm) billet in a rectangular cross-section, which is then ...
It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America. American historic carpentry is the historic methods with which wooden buildings were built in what is now the United States since European settlement.