Ad
related to: atx12v power supply design guide free
Search results
Results From The WOW.Com Content Network
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
To reduce the power losses in the 5 V supply, with the introduction of the Pentium 4 microprocessor, Intel changed the processor power supply to operate on +12 V, and added the separate four-pin P4 connector to the new ATX12V 1.0 standard to supply that power.
English: Pinouts of ATX power supply connectors, displayed according to Intel's Power Supply Design Guide for Desktop Platform Form Factors v1.2 (2008) and v1.31 (2013) COM = COMMON VSB = Volts Stand-By
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]
The University of North Carolina has agreed to pay new football coach Bill Belichick $10 million a year, according to a term sheet the university released Thursday afternoon.. While the agreement ...
The U.S. Department of Energy has zeroed in on three regions of the country it has determined are in major need of new electric transmission infrastructure and eligible for future federal funding ...
The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power. The power supply was instead turned on and off via a mechanical switch that disconnected mains power. Modern, ATX ...