Search results
Results From The WOW.Com Content Network
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
A GPIO port is a group of GPIO pins (often 8 pins, but it may be less) arranged in a group and controlled as a group. GPIO abilities may include: [2] GPIO pins can be configured to be input or output; GPIO pins can be enabled/disabled; Input values are readable (usually high or low) Output values are writable/readable
30 pin receptacle including the following electrical interfaces: 2-lane DisplayPort v1.1a, USB 3.0, USB On-The-Go, Analog stereo line-out, HDMI CEC for remote control, high output power line from both host and portable device Male Mini-VGA plug on top of an Apple laptop, female port is second from right. Mini-VGA (used for laptops)
Examples of computer connector sockets on various laptops Ports on the back of the Apple Mac Mini (2005) A computer port is a hardware piece on a computer where an electrical connector can be plugged to link the device to external devices, such as another computer, a peripheral device or network equipment. [1] This is a non-standard term.
The term can also be used as part of an action; to "perform I/O" is to perform an input or output operation. I/O devices are the pieces of hardware used by a human (or other system) to communicate with a computer. For instance, a keyboard or computer mouse is an input device for a computer, while monitors and printers are output devices.
The additional 24 pins provide the extra signals required to route I/O back through the system connector (audio, AC-Link, LAN, phone-line interface). Type II cards have RJ11 and RJ45 mounted connectors. These cards must be located at the edge of the computer or docking station so that the RJ11 and RJ45 ports can be mounted for external access.
Assigning the same interrupt to more than one printer port should be avoided and will typically cause one of the corresponding ports to work in polled mode only. The port addresses assigned to slot can be determined by reading the BIOS Data Area (BDA) at 0000h:0408h. Bit-to-pin mapping for the Standard Parallel Port (SPP):
The Video Graphics Array (VGA) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [1] as well as many monitors, projectors and HD television sets.