Ad
related to: difference mbps mb s and 1
Search results
Results From The WOW.Com Content Network
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
For Blu-ray discs, 1× speed is defined as 36 megabits per second (Mbit/s), which is equal to 4.5 megabytes per second (MB/s). [7] However, as the minimum required data transfer rate for Blu-ray movie discs is 54 Mbit/s, the minimum speed for a Blu-ray drive intended for commercial movie playback should be 2×. The fastest Blu-ray speed is 16×.
Transmission rates are defined by rate of the bitstream of the digital signal and are designated by hyphenation of the acronym OC and an integer value of the multiple of the basic unit of rate, e.g., OC-48. The base unit is 51.84 Mbit/s. [2] Thus, the speed of optical-carrier-classified lines labeled as OC-n is n × 51.84 Mbit/s.
List of interface bit rates. This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels. The distinction can be arbitrary between a computer bus, often closer in space, and larger ...
DS-1 is a communications protocol for multiplexing the bitstreams of up to 24 telephone calls, along with two special bits: a framing bit (for frame synchronization) and a maintenance-signaling bit, transmitted over a digital circuit called T1. T1 's maximum data transmission rate is 1.544 megabits per second.
Fast Ethernet is an extension of the 10-megabit Ethernet standard. It runs on twisted pair or optical fiber cable in a star wired bus topology, similar to the IEEE standard 802.3i called 10BASE-T, itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a). Fast Ethernet devices are generally backward compatible with existing 10BASE-T systems ...
It is intended primarily to save cost in low-bandwidth human interface devices (HID) such as keyboards, mice, and joysticks. Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0.
For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B/s, i.e. 8 GB/s, or approximately 7.45 GiB/s. The bit rate for this example is 64 Gbit/s (8 × 8 × 10 9 bit/s).